Recheck all assembly points to ensure a
secure column.
7. Next install the pedals. Place a small
amount of lubricant such as lithium grease
on the thread before installing. PLEASE
NOTE that the Right and Left pedals are
identified by the R or L stamped on the
end of the pedal shaft. The right pedal
screws in clockwise while the left pedal is
a reverse thread and screws in counter-
clockwise.
Tighten with a 15 mm pedal spanner or
15mm wrench (Figure 5).
Remember Right Pedal Tightens Clockwise,
Left Pedal Tightens Counter-Clockwise.
8. For proper gear adjustment the cable
tension must be checked to ensure there
is no slack in the cable when it is in highest
(fastest gear). Failure to do this can result
in poor gear changes.
COMMENTS/QUESTIONS? VISIT YOLOBIKE.COM
6. The handlebars have already been fully
wired in and around the frame. The handle
bar assembly must be installed to the
headset with a 4 mm hex key.
Use a 5 mm Hex key to loosen the handle
bar stem (Figure 1). Relocate and lock the
head stem hinge (Figure 2) after aligning
handlebars so they are perpendicular to
the front wheel (Figure 3).
If needed, adjust LCD display position for
best viewing by unscrewing and retightening
the screw underneath the display using a
Philips screwdriver (Figure 4).
Figure 3
Figure 5
Figure 4
Summary of Contents for Bolt
Page 1: ...O W N E R S M A N U A L...
