-26-
●
Check the undermentioned items in the event that a
tool does not shut off automatically.
・
if dynamic air pressure with the gauge of air piping at
free speed is maintained at 0.4-0.5Mpa(low-pressure) and
0.5-0.6Mpa (standard pressure).
・
if a long extension bar is used or not.
・
if a reverse lever position is set to (L) loosening direction.
A tool does not stop automatically with the reverse lever
set to (L) direction.
・
if an outlet of exhaust air on the motor case cover side is
blocked by tape and etc. or not.
If the tool does not shut off automatically even after check-
ing above items, inspection or repair should be necessary.
●
Long socket, larger sockets and so forth will cause
the slipping phenomenon.