-24-
●
Be sure to hang a tool securely.
Be sure to check if the hook of a balancer is fixed to the
hanger ring of the tool securely when hanging the tool to
balancers. Check the hanger ring and hook if there is any
damage, and replace them if needed.
■
Precautions for use:
●
Check the tightening direction
Operate a tool after confirming the direction of switching
lever. When switching the direction, make sure that the tool
is in stop condition.
●
Insert a socket securely in a bolt.
In order to avoid a socket to come off from a bolt during
operation, insert a socket securely in a bolt.
●
Place a bit securely into a screw.
In order to avoid a bit to come off from a screw during
operation, use the bits conforming to the sizes of screw
heads. ( + 1 size bit should not be used on the + 2 screw
with head) Also, do not place a bit over screw head diago-
nally and make sure to place it vertically over screw head.
●
Be prepared for reaction force
Be prepared for reaction force by holding the tool securely
since there is a chance that an operator might be pushed
around by the reaction force.
●
Be careful with the operation of a tool at no load.
When running the tool at no load, be sure that the tip tool
was removed without fail and be careful about the
surroundings. The operation at no load for a long time will
be the reason for the part breakdown with seizure, early
wear and so on.
●
Be careful of burn injury.
Make sure not to touch attachments carelessly because
attachments, bolts and nuts might have been heated up
after operation.
CAUTION