3-4
IM 707281-01E
3.3
Setting the Output Condition in the AG Mode
In this section, you will be using the operation panel that appears by double-clicking the
module icon in the station list window as shown in the figure below and the trigger and
Misc operation panels that appear by clicking the Trig and Misc tabs, respectively.
Select the output channel
Select the output range
Select the output mode
Execute manual trigger
Turn ON/OFF
waveform output
Selecting the Output Channels and Range
Click the [On] box of the channel you wish to output. Select the range from [1 V], [2 V],
[5 V], and [10 V] in the [Range] list box.
Selecting the Output Mode
Select the output mode using the [Output Mode] buttons. The default is [One Shot].
One Shot: Single shot oscillation
Outputs the waveform once when the output is turned ON by clicking the [Output] button.
Cont: Continuous oscillation
Continuously outputs the waveform of the block specified by [Start Block No.], from the
time the output is turned ON by clicking the [Output] button until the output is turned OFF
by again clicking the [Output] button.
Trigger: Trigger oscillation
After the output is turned ON by clicking the [Output] button, the waveform set in blocks
[Start Block No.] through [End Block No.] are sequentially output every time a trigger
occurs. When block [End Block No.] is reached, the oscillation returns to the [Start Block
No.].
Repeat: Repetitive oscillation
After the output is turned ON by clicking the [Output] button, the waveform set in block
[Start Block No.] is repetitively output when a trigger occurs.
Note
When the output is OFF, the waveform output terminal of the module outputs 0 V.