1-2
IM 707235-01E
1.2
Operation Panel
The WE7000 Control Software that is installed in the PC is used to control the WE7235
4-CH, 100 kS/s Accelerometer Module. The WE7000 Control Software displays
operation panels similar to those shown in the figure below. This user’s manual does not
explain the operations of the operation panel or waveform monitor. For the operations of
these items, see the on-line help that is provided with the WE7000 Control Software.
Setting the Measurement Conditions
Start/Stop measurement
Select measurement unit
Select the measurement range/gain
Set the sampling
interval
Select the acquisition
mode
Turn measurement ON/OFF
Set the number of memory partitions
Set the record length
Set the number
of acquisitions
(Number of
memory block used)
Select the check box during
continuous measurements
(only during the trigger mode)
Turn ON/OFF waveform monitor
Set the acceleration sensor
sensitivity
Switch to the window used
for detailed configuration
Turn ON/OFF the supply current to the acceleration sensor
Select the input coupling
Setting the Trigger
Set the trigger
level
Select the
trigger type
Displayed when More Option clicked
Select the trigger
combination
Set the pretrigger
Select the trigger
source
Set the trigger hold off
Trig tab
Enable overlap
acquisition
Displayed when the Trig tab is clicked
Other Settings
Displayed when More Option clicked
Displayed when the Trig tab is clicked
Set the input filter
Select the time base
Select the number of
measurement channels