20
IM 701450-61E
Setting the Computed Waveform of Joule Integral (When I
2
t Was Selected in Step
4 on Page 18)
5.
Use
jog shuttle & SELECT
to set the computation source waveform, scaling,
unit, and computation start point of computed waveform Math1.
Select I
2
t.
Select the waveform on which to perform computation.
Set the scaling used to display computed waveform Math1 or
Math2 to Auto (auto scaling) or Manual (manual scaling).
If scaling is set to Manual, set the vertical center line level on the
screen (Joule integral value) and the sensitivity (Joule integral
value per division).
Set the unit of computed waveform Math1 or Math2.
Set the computation start point.
6.
Press
ESC
. The Math1 Setup dialog box closes.
Setting the Computed Waveform of Power Spectrum (When PS Was Selected in
Step 4 on Page 18)
5.
Use
jog shuttle & SELECT
to set the computation source waveform, scaling,
unit, computation start point, and time window of computed waveform Math1.
Select PS.
Select the waveform on which to perform computation.
Set the scaling used to display computed waveform Math1 or Math2
to Auto (auto scaling) or Manual (manual scaling).
If scaling is set to Manual, set the vertical center line level on the
screen (voltage value if set to voltage) and the sensitivity (voltage per
division if set to voltage).
The unit is fixed to dBV when the waveform to be computed is CH1,
CH3, or CH5 and dBA when the waveform to be computed is CH2,
CH4, or CH6.
Set the computation start point.
Select the number of computed points.
Select the time window.
6.
Press
ESC
. The Math1 Setup dialog box closes.
7 Performing Waveform Computation on Power Analysis Parameters
