9
IM CW500-02EN
1.
Check that the power is turned off and that cables are not connected.
2.
Using a flathead screwdriver, unfasten the screws holding the battery
cover on the rear panel, and open the battery cover.
3.
Insert batteries into the battery holder. Pay attention to their polarity.
Batteries that can be used:
AA alkaline batteries (LR6, 1.5 V)
6 pcs.
AA nickel-metal hydride batteries (Ni-MH) 6 pcs.
4.
Close the battery cover, and fasten it with the screws.
Screws
Battery cover
Batteries (6 pcs.)
Battery Level Indicator
Depending on the battery level, the following indicators appear on the
screen.
With alkaline batteries, measurement is possible for about 3 hours.
With nickel-metal hydride batteries (1900 mA/h), measurement is
possible for about 4.5 hours (reference value with the LCD turned off).
Normal measurement
Because the voltage of a fully charged nickel-metal hydride battery is
less than that of alkaline battery, the indicator may not go higher than
these indications.
Measurement continues, but data saving is stopped.
(The measured data up to when data saving is stopped will be saved.)
Power Supply