YOKOGAWA 53005-E, User Manual, Page: 11 / 24

11
1
Pressing the MEASURE button blinks
“ALM”. Then,“ON”or“OFF” (currently
set status) is displayed on the top of
LCD and
“AL-H” is displayed on the
sub-display. (The High alarm is set up.)
2
Press the ▼ /MAX/MIN or
▲ /MAX/MIN button to select ON or
OFF, and then press the MEASURE
button to confirm the setting.
When OFF is selected, the display
shifts to the setting for the Low
temperature alarm.
3
Press the SET button
while the power is ON.
The alarm temperature is displayed on
the top of LCD by selecting ON.
Press the
▼ /MAX/MIN or
▲ /MAX/MIN button to select ON or
OFF, and then press the MEASURE
button to confirm the setting.
When the setting has been completed,
the display shifts to the setting for the
Low temperature alarm.
4
For the setting/resetting of the Low temperature alarm, the above steps can be
appliedexcluding that
“AL-H” on the sub-display is changed to “AL-L” in step 2 and later.
When the lower limit setting has been completed, the mode is changed to HOLD.
When the upper and lower limit alarms are set,
“HI” and “LO” lamps are lit on the display.
Note) The High alarm value cannot be set to the value less than the setting for the Low
temperature alarm, and the Low alarm value cannot be set to the value more than the
setting for the High temperature alarm.
Setting/Resetting the High/Low Temperature Alarm
When the measured temperature exceeds the High alarm value, the alarm LED blinks in red and a
buzzer (high tone) sounds. When it is below the Low alarm value, the alarm LED blinks in green and
a buzzer (low tone) sounds. The “High alarm” is set up first, and then the “Low alarm”.
Set up the alarms according to the following steps.
Pressing the SET button displays
“ALM” on the top of LCD.
(Regarding 53006, the display is
switched in order of
“ALM”, “EMS” and
“TIME” each time the SET button is
pressed.)
SET
53005-6E 12.5.12 10:04 AM ページ 11