INST
ALLA
TION
INSTUCTIONS
1) Mounting Indoor & Outdoor
Units and Running
Piping/Wiring
Ruler (Not Shown)
Stud-Finder
Dry-Wall Saw
Electric Drill
3" Hole Saw
Drill Extension
Hammer Drill and Bit (Not Shown)
Measuring Tape
Level
Flash Light
Screw Driver (Phillps and Flat)
Hammer
Knife
Scissors
Goggled Glass
Mask
Gloves
Ladder
2) Refrigeration Related Work
RECOMMENDED TOOLS FOR INSTALLATION
3) Electrical Related Installation
Wire Cutter
Wire Stripper
Sharp Plier
Cable Ties
Black Tape for Electrical Use
lectrical Meter
Clamp Meter (Not Shown)
Manifold
Infra Thermometer (Not Shown)
4) Trial Running Units and
Inspection
Individual Wrentch Set (Use Two at
One Time)
Flare-Nut Tool Set (Not Shown)
Hex Head Allen Wrentch Sets (Metric
and Imperial)
Brazing Rods and Brazing Torch
Outfit for AC Application (Not Shown)
Brazing Flux
Nitrogen Cylinder for Positive
Pressure Leakage Check (Not Shown)
Soap Bubble for Positive Pressure
Leakage Check (Not Shown)
Vacuum Pump for Negative Pressure
Leakage Check
Helium Refrigerant Minor Leakage
Check (Not Shown)
Manifold
INST
ALLA
TION
INSTUCTIONS
P16 OF 34
P15 OF 34
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
INSTALLING OUTDOOR UNIT
LOCATION
Use bolts to secure the unit to a flat, solid floor.
When mounting the unit on a wall or the roof,
make sure the support is firmly secured so that
it cannot move in the event of intense
vibrations or a strong wind.
* Do not install the outdoor unit in pits or air vents.
* Do not install the outdoor unit where it is exposed
to direct sunlight.
INSTALLING THE PIPES
Use suitable connecting pipes and equipment
for the refrigerant R410A.
The refrigerant pipes must not exceed the maximum
lengths given in the technical data table.
Lag all the refrigerant pipes and joints.
Tighten the connections using two wrenches working in opposite directions.
Install the drain fitting and the drain hose (for model with heat pump only)
Condensation is produced and flows from the outdoor unit when the appliance is operating in the heating mode.
In order not to disturb neighbors and to respect the environment, install a drain fitting and a drain hose to
channel the condensate water. Install the drain fitting and rubber washer on the outdoor unit chassis and connect
a drain hose to it as shown in the figure.
After having removed the packaging, check
that the contents are intact and complete.
Handling must be done by suitably equipped
qualified technical personnel using equipment
that is suitable for the weight of the appliance.
The outdoor unit must always be kept upright.
HANDLING
INSTALLATION CLEARANCE
8" or above
Space to the cover
78" or above
(Air outlet side)
10" or above
Space to the wall
20" or above
Space to the wall
6" or above
(Air inlet side)
W
H
