YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
25
All Units Shall Be Installed by Licensed Contractors or Technicians.
Read Manuals before Installation.
•
The location and structure should also be convenient for both installation and service.
•
The location should NOT be where discharge air and noise could annoy a neighbor.
•
The location should NOT be where drain may cause any damage to property or annoy a neighbor.
•
The location should NOT be where brazing work may cause fire or smoke to the surrounding materials.
•
The location should NOT be near flammable gases.
•
The location should NOT be in or close to corrosive gases.
•
The location should NOT be where children can access.
CAUTION & SUGGESTIONS TO FOLLOW PRIOR TO INSTALLATION
Check the unit for damage and missing parts or accessories. If there is damage found or parts are found
missing, call the distributor right away.
Spin fan wheels or blades to check if they can rotate freely. If the fan wheel scratches the housing, call the
distributor right away and do not proceed with the installation until it is fixed.
Check the unit to make sure no foreign materials have been left inside the unit.
Check to be sure you have all the additional parts and accessories that are required for the installation and
those provided with the unit.
It is strongly recommended to only use YMGI supplied or approved parts and accessories.
Be sure a properly sized circuit breaker is installed for the electric power suppling the units.
Pre-build the support platform on the ground or bracket for the wall before or during construction and before
installation.
Read installation instructions for all units thoroughly.
Ask rep./distributor/YMGI Group anything you are not sure about.
Get your tools and parts ready and start the installation.
BASIC REQUIREMENTS FOR THE INSTALLATION LOCATION
Choose a location where there are no strong heat sources, vapors, flammable gas or volatile objects.
Choose a location where there are no high-frequency waves being generated by radio equipment, welders and
medical equipment.
Choose a location where there are not a lot of salinities, such as coastal areas.
Choose a location where there is no oil (machine oil) contained in the air.
Choose a location where there is no Sulfur gas present, such as areas close to hot springs.
Choose a location where there is no other special circumstance.
SELECTION OF INDOOR UNIT INSTALLING LOCATION
The air inlet and outlet vent should be far from any obstructions, making sure that the air can be blown through
the entire room.
Select a location where the condensate water can be easily drained, and can be easily connected to the outdoor
unit.
Select a location where children cannot reach the unit.
Select a location that is strong enough to support the full weight of the unit and the vibration which will allow the
unit to operate more quietly.
Be sure to leave enough space to allow access for routine maintenance. The height of the installed location
should be 78 inches or more from the floor.
Select a place about 3 feet or more away from television or any other electric appliances.
Select a place where the filter can be easily maintained.
Make sure that the indoor unit is installed in accordance with the dimensioned diagram.
