2. THERMAL CONTROL SETTINGS
Unicorn is equipped with active thermal control system that changes brightness
depending on the degree of heating of the flashlight. The flashlight is already set up for
comfortable work, temperature threshold is 50
°C
; sensor is calibrated at room
temperature of 25
°C
.
If necessary, you can reconfigure the thermal control limit on your own, or reset the
settings and recalibrate the temperature sensor.
2-1. Manual thermal control setting
Allows setting a comfortable degree of flashlight heating:
1) Enter the engineering menu (screw the cap until tight while holding the button);
2) Turn on the flashlight on Maximum and wait for the desired temperature;
3) Execute a “9 hold” command, current temperature of the flashlight will be set
as an operating threshold of a thermal control.
4) After 1-2 seconds exit the engineering menu.
The default threshold for thermal control is 50
°C
.
Please note that the thermal control is working in
the process of the setting, so you can not heat the lamp substantially above 50 degrees.
The set temperature will be used in all UIs, but it will be reset to default when the flashlight
is reset (12 clicks) or when the temperature sensor is calibrated.
2-2. Temperature sensor calibration
This function allows resetting temperature control and re-calibrating temperature sensor
of the flashlight. During calibration, current air temperature will be recorded as 25
°C
, the
temperature sensor will proceed from this value during temperature measurements.
Adjustment must be made at a room temperature (~ 25
°C
); the flashlight should not be
heated by working before the adjusting.
1) Enter the engineering menu;
2) Execute the command “20hold”, the button will flash green.
3) After 1-2 seconds exit the engineering menu.
The results of the temperature sensor calibration will stay even after resetting of the
flashlight. Also, when calibrating the temperature sensor, the results of manual
adjustment of the temperature control will be automatically reset (p.2-1).
