1-4. Changing of preconfigured user interfaces
If needed, you can customize a configuration of settings and save it instead of any of
three UIs. If current configuration was not saved, it will be lost.
For example, you configured the functions you need, and now you want to save current configuration
as UI 1:
- enter the engineering menu (screw the cap until tight while holding the button);
- execute the command “set current configuration as UI 1” (13 hold), the button will flash green;
- after 1-2 seconds exit the engineering menu.
Now UI 1 matches your individual configuration of settings. Similarly, you can configure all three UIs, as well
as ways to switch between them.
All individual interface settings will be reset when the flashlight is completely reset to the
factory state (12 clicks).
