ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
5
6
Instructions
Congratulations! This YITAHOME bidet is ready to be used.
Firstly, please make sure all parts are tightened without leaks or movement.
Secondly, please confirm the bidet are in good condition. If not, please read
the "Troubleshooting" for solutions or contact our customer
service: [email protected]
1. Switch to “Rear Wash” and you will hear a click sound to designate rear washing
2. Switch to “Women” and you will hear a click sound to designate feminine washing
Adapter
Valve
Flexible hose
Bidet
5.
Disconnect the water supply
hose from toilet tank.
Connect the top of the T-adapter
to the toilet tank and the bottom
of the T-adapter to the water
supply hose.
6.
Connect the bidet hose to the
T-adapter and bidet inlet.
Use a wrench to fully tighten
connections on both ends
of the hose.
1. Knob Switch to Toggle Cleaning Modes
1
2
3
1. Increase water pressure: rotate the knob to be away from “OFF” icon
2. Decrease water pressure: rotate the knob to approach “OFF” icon
2. Knob Switch to Adjust Water Pressure
3. Knob switch to the middle("OFF") to turn off the bidet and
you will hear a click sound.
OFF
OFF
OFF
OFF
Rear
Wash
OFF
Women
Rear
Wash
Women
Rear
Wash
Women
Rear
Wash
Women
Rear
Wash
Women
Notes
- Do not flush the toilet when bidet is in use.
- Don't connect the bidet to heat water supply. It should only be connected
to cold water.
- Gently adjust the water pressure. Avoid the highest pressure to reduce the
risk of injury.