- 21 -
surface of the part, otherwise it will corrode the surface.
Apply clean water if it is on your skin.
The front and rear brakes are disc brakes, and professional maintenance personnel should
be required for maintenance when maintenance.
The rear wheel disassembling
1. Prop up the motorcycle with wooden stool or other relatively fixed
supports to keep the two wheels off the ground and balance.
2. Loosen the lock nut ①of the drive chain regulator and the drive
chain adjuster on both sides.
Loosen the rear wheel nut②and push the rear wheel forward.
3. Remove the retaining clip of the transmission chain to remove the
transmission chain.
4. Remove the rear axle nut, pull out the rear axle③, and then remove the rear wheel.
The rear wheel installation sequence is the reverse of the disassembly. The rear axle nut
torque :(50 ~ 60)N
·
m[(5.0 ~ 6.0)kg
·
m] adjust the brake and chain according to the relevant
chapters.
After loading the rear wheel, brake several times, the rear wheel
should be free to rotate when the brake is rechecked.
Battery maintenance
The battery is located under the right cover, and the right lid can be seen.
This car adopts 12V/ A battery ①.
Check the mileage between the periodic table and the pre-driving test.
Warning
: when engine crankshaft speed is above 2500r/min, it is possible to ensure that heavy
duty electrical appliances (such as headlights and brake lights) on
motorcycles will not cause excessive battery consumption.
Users should avoid using all kinds of power-consuming devices
(especially headlamps, brake lights, etc.) when the engine is out of fire.
When the vehicle is not used for a long time, the battery should be
unloaded.
When dismantling, the negative electrode lead should be removed
first.
After charging, place it in a well-ventilated place to avoid light;
