YewdaleDefiant
®
Manufacturing instructions
Part no: 998
6
Manufacturing Instructions
YewdaleDefiant
®
Vertical blinds (VL30 Single Draw R/H Control)
13
.
Slide the shaft support with magnet onto the spline (927004W).
14
.
Cut the cord (7250W) to the correct length using the formula below.
Actual blind with + drop x 2 minus 400mm
15
.
Take one end of the cord and thread it through the bottom of the pulley on
the drive end of the control set closest to the spline and through the trucks
as shown in fig 1 into the cord drive runner (927005W), as shown in fig 2.
Once in place secure with block and screw provided.
16
.
With the other end of the cord, thread through the second pulley in the
drive end of the control set and then through the trucks (outside edge of
trucks), through the cord drive runner, round the idle end of the control set
and back into the cord drive runner. Once in place secure with the block and
screw provided.
Fig 1.
Fig 2.
N.B The metal plate has been removed
to enable the cord to be seen
N.B The metal plate has been removed
to enable the cord to be seen
