YewdaleDefiant
®
Manufacturing instructions
Part no: 998
4
VL30 Single Draw R/H Control:
1
.
Check the profile - part number (927000W), and spline – (927006), are free
from damages
2
.
Cut the profile (927000W) 17mm less than the blind width
3
.
Cut spline (927006) 28mm less than the blind width.
4
.
Build part 927001RW/LW using the five components supplied, leaving the
screw cover cap off at this stage.
5
.
Insert spline into drive end of control set (927001RW if right hand control
or 927001LW if left hand control) and drill a hole through the connected
parts with a 2mm drill bit and secure it in place with pin (927013), using pin
hammer.
6
.
Select the appropriate trucks:
• If left hand control and 127mm, use 927002L
• If right hand control and 127mm, use 927002R
• If left hand control and 89mm, use 927003L
• If right hand control and 89mm, use 927003R
7
.
Using the formula below, calculate the amount of trucks needed.
Actual blind width ÷ actual link length
For example, for a 400mm blind:
89mm louvre (the actual link length is 79mm) 400÷79mm = 5pcs
127mm louvre (the actual link length is 115mm) 400÷115mm = 4pcs
Round the figure up to next whole number.
Manufacturing Instructions
YewdaleDefiant
®
Vertical blinds (VL30 Single Draw R/H Control)
