Yetter CAB CONTROL STRIP FRESHENER 2984-050-R, Operator'S Manual

Page: 11 / 36

11
Assembly Instructions
Mount the Control Box
Attach the 2984-
512 Ram ball base to the tractor’s monitor mounting device. Some tractors have round tube & some have slotted
flat steel. Pick a location near the right rear corner post so that adjustments can be made easily while viewing the strip freshener
units’ performance. Attach the double socket arm to the tractor mounted ball and the control box mounted ball and tighten the T-
knob to fix the control box into place.
Plumbing the Control Box
Route the tubing harness (10ft of tubing side) into the back of the tractor cab & plug the tubing into the side of the control box
connector.
1
– compressor; 2 – row cleaner down, 3 – row cleaner up, 4 – row unit down force, 5 – rolling basket down, 6 – rolling basket up
The center port is not used. The 5ft of tubing on the other side of the hitch bulkhead connector will plumb into each corresponding
circuit on the toolbar.
1
– compressor; 2 – row cleaner down, 3 – row cleaner up, 4 – row unit down force, 5 – rolling basket down, 6 – rolling basket up
Plumbing the Compressor
Insert the 1200-353 3/8 Stem to 1/4
PC reducer into the outlet 3/8” outlet elbow on the compressor. Install the ¼” airline from the
tubing harness labeled COMP into the ¼”PC.