Yetter CAB CONTROL STRIP FRESHENER 2984-050-R, Operator'S Manual

Page: 8 / 36

8
Assembly Instructions
Hydraulic Compressor Assembly (if ordered)
Prepping
– The crate labeled 2940-055 should include the Yetter hydraulic compressor, 1 liter bottle of oil, 2940-181 hyd. comp.
solenoid/pressure switch harness, & 2940-
189 10’ hyd. communication harness. The 2940-181 & 2940-189 can be discarded if
2940-114 Stand Alone Kit was ordered. Remove compressor from crate. Remove housing by removing 6 bolts (4 are pictured in
picture 1 below, the other 2 are on opposite side of the housing) using a ratchet with 7/16 socket & a 7/16 wrench. Remove the
dipstick & slowly fill pump with provided oil until oil reaches the fill line on the sight glass. Fill pump slowly as there is a significant
delay between oil entering pump & seeing oil on the sight glass. Confirm the oil level is full on the dipstick as well. Reinstall the
dipstick, housing, & control block. Remove the wing nut on the air filter housing, remove the air filter cover, & inspect the condition
of the air filter. Reinstall the filter, cover, & wing nut making sure the filter is sealed between the filter base plate & cover.
Mounting
– Each strip till machine will have its own unique mounting location. Select an area to mount the compressor that is
centrally located near hitch of tractor. YOU SHOULD EXERCISE YOUR OWN BEST JUDGEMENT TO FIT YOUR SITUATION.
Use mounts supplied or depending on application different mounts may need to be built or Yetter mounts may need modified. Be
sure to check clearance in all locations, especially noting tractor tires, folding/unfolding toolbar for transport mode, marker arms, &
fertilizer tanks. The 2940-086 universal mount kit will be most commonly used mount for this application.