7
ASSEMBLY INSTRUCTIONS
Attaching the 5” x 5” coulter toolbar to the hanger bar
STEP 3
. A coulter will be mounted on the cart directly in line with each opener on the implement that will be mounted
on the cart. Most implements have an even number of openers with no opener in the center, measure the length of
the 5” x 5” toolbar and mark the centerline.
STEP 4
. Align the center of the coulter toolbar with the center of the frame. Attach the 5” x 5” toolbar to the rear of
the hanger bar using the offset brackets, ¾” u-bolts, and ¾” lock nuts. Rigidly fasten one bracket between the toolbar
with the rear u-bolt on the center line (on even number of coulters) of the coulter toolbar. Assemble the four
remaining brackets to the toolbar; refer to the illustration below. The location of the bracket is determined by the
width of the toolbar and the row spacing of the implement.
SEE THE FOLLOWING PAGE FOR EXACT BRACKET LOCATIONS
Summary of Contents for 6300
