![background image](http://html1.mh-extra.com/html/yetter/5000-023a/5000-023a_operators-manual_3459448008.webp)
8
5000-023A & 5000-024A ASSEMBLY INSTRUCTION
STEP 6:
Install the push rods into the mount brackets & attach to the pivot arms using the 5/8” Shoulder Bolts
5/8” Washers, & ½” Jam Nuts. The washers are to be installed on each side of the “Eye” on the push
Rod. Now install the Compression Springs, Spring Bushings, & ¾” Lock Hex Nut.
STEP 7:
Attach the roller mounts to the over bearing arms, & then install the ½” X 3 ¾” Bolts, Spacers, & ½
Lock Nuts. Slide the roller mount tubes side to side as needed to clear the end of the corn head.
NOTE:
Make sure the Bearing Support Tab in on the backside of the Bearing Mounting Plate.
2 ROW ROLLER ASSEMBLY
3 ROW ROLLER ASSEMBLY
STEP 8:
Install the Shim Washers & Bearing onto each side of the Roller.
NOTE:
The side of the Bearing protruding on the outside of the casting should face the Roller.
Attach the Roller/Bearing assembly to the Roller Mount Tube using ½” X 2 ½” Bolts & ½” Lock Hex Nuts.
Summary of Contents for 5000-023A
