![background image](http://html1.mh-extra.com/html/yetter/5000-023a/5000-023a_operators-manual_3459448011.webp)
11
5000-035A ASSEMBLY INSTRUCTION
STEP 6:
Install the Push Rods into the Mount Brackets & attach to the Pivot Arms using 5/8” Shoulder Bolts,
5/8” Washers, & ½” Jam Lock Hex Nuts. The Washers are to be installed on each side of the “EYE” on
the Push Rod. Now install the Compression Springs, Spring Bushings, & ¾” Lock Hex Nuts.
STEP 7:
Attach the Roller Mounts to the Overbearing Arms, & then install the ½” X 3 ¾” Bolts, Spacers, & ½”
Lock hex Nuts. Slide the Roller Mount Tubes side to side as needed to clear the end of the Corn Head.
NOTE:
Make sure the Bearing Support Tab in on the backside of the Bearing Mounting Plate.
2 ROW ROLLER ASSEMBLY
3 ROW ROLLER ASSEMBLY
STEP 8:
Install the Shim Washers & Bearings onto each side of the Roller.
NOTE:
The side of the Bearing Protruding on the outside of the casting should face the Roller.
Attach the Roller/Bearing Assembly to the Roller Mount Tube using ½” X 2 ½” Bolts & ½” Lock Hex Nuts.
Summary of Contents for 5000-023A
