16.
17.
DERAILLEUR HANGER INSTALLATION
01. HANGER SEAT
02. HANGER CAP SEAT
Lightly grease the outside surface of the hanger
where it interfaces with the frame. The hanger
will fit into its space on the inside of the swingarm
and presses easily into the frame.
Lightly grease the threasd on the hanger cap.
The hanger cap REVERSE threads into the
hanger from the outside of the swing arm. Hand
thread the cap into the hanger.
03. TIGHTENING
02. COMPLETED
Using a 6mm allen key, tighten the hanger cap
into the hanger. REMEMBER, it is REVERSE
THREADED. Follow the “Tighten” arrow on the
cap.
*Torque to 80 in/lbs (9Nm)
The installed hanger and cap should look like this,
sittign flush against the frame on both the inside
and outside of the swing arm. If the hanger
or cap are not sitting fluch against the frame,
remove them and inspect the frame surfaces for
debris as well as the threads for damage.
NOTE: The hanger cap is REVERSE
THREADED. Be careful not to strip out the
Hanger tool faces. The cap is marked with a
tighten direction arrow.
Inspect the frame around the hanger seat for
any suspicious damage any time you replace
a hanger, but especially if you are replacing it
due to damage.
YETI TIPS
TOOLS NEEDED
• 6mm Allen key
• Grease
DERAILLEUR HANGER INSTALL
Summary of Contents for SB6C 2016
Page 1: ...OWNER SMANUAL 2016YETISB6C...
