22.
23.
ASSEMBLY
ASSEMBLY
Place the steel washer on the lower link bolt and
apply pink Loctite (222).
Using two 5mm allen wrenches tighten the lower
link pivot pin. Use a properly calibrated torque
wrench to finish the job.
Torque to 13 Nm
Slide the swingarm into place over the Switch
Infinity Link and align the main pivot. Apply a
small amount of grease to the un-threaded part
of the main pivot pin. Apply pink Loctite (222) to
the threads.
05.
06.
08.
07.
Slide the main pivot pin through the swingarm
and Infinity Link using a Fox Guide Pin to align
the bearing spacer. Use a soft mallet to help
if needed. Lightly thread the pivot pin into the
swingarm using a 10mm allen wrench. Do not
torque yet.
Prepare and install the upper link pivot pin the
same way you install the main pivot pin. Use the
Fox Guide pin to align the bearing spacer as you
slide it through the link. Again, do not torque yet!
Using Fox Guide Pins, install the rear shock as
shown. Insert the guide pins from the drive side.
Lightly grease the shock mounting hardware,
install the appropriate washer and place the
female sleeve over the Fox Guide Pin.
09.
10.
11.
12.
Insert the link and align the lower pivot. Place
the steel washer over the pivot pin, apply a small
amount of grease, and using a Fox Guide Pin to
align the bearing spacer insert the pivot pin. Use
a soft mallet to tap it through if needed.
Summary of Contents for SB6C 2016
Page 1: ...OWNER SMANUAL 2016YETISB6C...
