20.
21.
FRAME ASSEMBLY
Make sure your tools are in good condition.
A worn allen key can round the hex on a bolt
not allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads. The instructions denote whether to
use a Loctite compound or grease.
YETI TIPS
TOOLS NEEDED
Warning: Service on Yeti bicycles requires special knowledge
and tools. Yeti Cycles recommends that all service and
repairs be performed by an authorized Yeti Dealer
• Dead blow hammer
• 2.5mm allen key
• Two - 5mm allen keys
• Two - 6mm allen keys
• 10mm allen key
• Guide pin tool
• Lock ring pliers
• Grease
• Blue (248) Loctite
• Pink (222) Loctite
• Torque wrench
All the parts you’ll need to get your SB6c put
together.
Slip washers onto and apply blue (248) Loctite to
the 4 bolts that secure the Switch Infinity Link to
the frame. Insert them into their place and hang
the black Infinity link fitting washers from them.
Place them with the flat side toward the opening.
Insert the Infinity Link from the non-drive side.
The Infinity logo should be up and the Fox logos
facing the non-drive side. Rock the link into
place capturing the black fitting washers. Make
sure that they have not slipped or rotated. The
flat end of the fitting washers must be facing the
opening in the frame.
01.
02.
03.
04.
While holding the link in place lightly tighten the
bolts. You want them to snug so that the link
does not move and so that the fitting washers
are fully captured, but don’t try to torque them by
hand! Finish the job with a torque wrench.
Torque to 12 Nm
Summary of Contents for SB6C 2016
Page 1: ...OWNER SMANUAL 2016YETISB6C...
