16.
17.
remove the drive side rubber bumper by
unthreading the m4 button head bolt with a 3mm
allen key.
fork setup
Before riding the 303-wC it is extremely important that the clearance between the upper
fork crown and the top tube on the frame is checked. if improperly set up the fork crown can
contact the top tube causing irreparable damage to the frame. please consult the following
instructions for all fork installations on the 303-wC.
overview
01.
if the upper crown touches the top tube before
the stanchion touches the bump stop housing
add headset spacers under the upper crown until
there is at least 5mm of clearance between the
top tube and upper crown. Using a rock shock
Boxxer “tall” upper crown will require a minimum
of 10mm of spacers for adequate clearance.
03.
Caution: the failure to properly set up the fork on the 303 Wc can cause serious and irreparable damage to
the frame. if you have any concerns about proper fork setup please consult your local authorized dealer..
slowly rotate the fork clockwise. if the fork
stanchion touches the outer face of the bump
stop housing before the upper crown touches the
top tube, the fork is properly set up.
02.
install the drive side rubber bumper with a 3mm
allen key.
torque to 5-10 in/lb.
04.
