24.
25.
assembly
make sure your tools are in good condition.
a worn allen key can round the hex on a bolt
not allowing for proper torque.
torque settings are listed throughout the
instructions. it is also import to prep all bolt
threads. the instructions denote whether to
use a blue loctite compound or grease.
while the assembly of the 303 wC is possible
with standard allen wrenches, the use of a
small ratchet with allen key bits will greatly
increase the ease of assembly.
yeti tips
tools neeDeD
Warning: service on Yeti bicycles requires special knowledge
and tools. Yeti cycles recommends that all service and
repairs be performed by an authorized Yeti dealer
• Dead blow hammer
• 3mm allen key
• 4mm allen key
• two - 5mm allen keys
• two - 6mm allen keys
• Guide pin tool
• Grease
• Blue loctite
attach the car mount to the guide with two m6 ti
male bolts prepped with washers and blue loctite.
Orient the car mount so the cutaway fits around
the grease port on the guide.
torque to 90-95 in/lb.
prep four m4x8mm shC bolts with washers and
blue loctite. install the bolts through the lower two
holes on each side of the car mount and into the
guide with a 4mm allen key.
torque to 30-35 in/lbs.
attach the guide assembly to the frame using four
m6x1x25mm shC bolts prepped with washers
and blue loctite. the cutaway and grease port
should be at the top of the rail assembly. tighten
the bolts with a 5mm allen key.
torque to 125-130 in/lbs.
slide the dogbone over the top tube and align it
with the bore in the frame. ensure the side of the
dogbone with the smaller flat surface faces the
front of the frame.
01.
02.
03.
04.
