Yedoo OOPS AMBULANCE, User Manual

Page: 9 / 96

9
EN
2.
4. 5.a
3.a 3.b
Place the wheel into the front fork so
that is well-centered and tighten the
nuts (
1, 2 ). (For easier installation you
can turn the balance bike upside down).
If the tire has an arrow-shaped tread
pattern, the arrows should be pointing
to the front.
Adjustment of brake levers
(does not apply for OneToo without
brake)
Incline the brake levers correctly by
loosening the screw on the sleeve (
1 ).
The right inclination:
Let the child sit on the balance bike, hold
the handles and stretch out your fingers
in a way that his/her arm and the fingers
form a single straight line. This should
be the position of the brake lever.
Adjustment of brake
(does not apply for OneToo without
brake)
Before adjusting the brakes, inflate the
tires according to the values on their side
(ideally between 1,3 and 1,8 bars). Check
that the brake pads fit tightly on the rim
sides. Their position can be adjusted via
the screws (
1 ). The pads shall not touch
the tires.
Seat installation
Put the seat tube into the frame ( 1 ) of
the balance bike, adjust the desired
height (do not exceed the maximum
mark) and tighten the sleeve screw (
2 ).
YooToo, TooToo, 112
Front wheel installation
Make sure the front fork of the balance
bike is well positioned (the bending of
the fork faces forward).
5.b
Check that the pads make enough
space (1–2 mm) after releasing the brake
levers. The distance can be adjusted by
tightening or loosening the brake cable
at the anchor screw (
2 ).
1
10 Nm
1 1
1
1
5 Nm
2
10 Nm
2
1
2
6 Nm
2
Max