Yedoo ALLOY WOLFER, User Manual

Page: 11 / 136

11
EN
10b. 10a.
Adjusting the angle of the brake levers
On both brake levers loosen the screw
on the sleeve. For the best results, stand
on the footrest, grab the handlebars and
stretch your fingers so they extend in
a straight line from your hands. Set the
brake levers in this position and tighten
the two mounting screws.
You can adjust the position of the
handlebar ends on the
Yedoo Wolfer
and Wolfer RS model using the
mounting screws shown on the picture.
9a.
Installing the brake cables
Squeeze the brake lever to the maximum
and insert the end of the brake cable
into the round lug (
1 ). Insert the cable
into the groove and tighten the set
screw (
2 ) and the nut ( 3 ). Repeat the
process with the other brake. The rear
brake cable is usually mounted on the
right brake lever and the front brake
cable on the left.
1
2
3
6–7 Nm 6–7 Nm
9b.
Wolfer and Wolfer RS use special levers
that enable correct change of lever
according to the type of brake. If the
brake lever controls a V-brake (rear
wheel), the brake wire needs to be put
in position (
1 ). If the brake lever controls
a front Caliper brake (front wheel), the
brake wire needs to be put in position (
2 ).
Setting up the position: Press the
brake lever slightly, in order to see the
attachment of the brake wire. Turn the
safety pin and move the attachment of
the brake wire to the required position.
By turning the safety pin again, you will
lock the attachment of the brake wire.
9c.
1
2