Yeastar Technology MyPBX, User Manual

Page: 22 / 133

MyPBX Standard User Manual
www.yeastar.com Page 22
· Busy Count
If Busy Detection is enabled, it is also possible to specify how many busy tones
to wait for before disconnecting the call. The default is 4, but better results can
be achieved if set to 6 or even 8. Remember, the higher the number, the more
time will be required to release a channel. A higher setting lowers the
probability that you will encounter random hang-ups.
· Busy Interval
The busy detection interval
· Busy Pattern
If Busy Detection is enabled, it is also possible to specify the cadence of your
busy signal. In many Countries, it is 500 msec on, 500 msec off. Without Busy
Pattern specified, MyPBX will accept any regular sound-silence pattern that
repeats <Busy Count> times as a busy signal. If you specify Busy Pattern, then
MyPBX will further check the length of the tone and silence, which will further
reduce the chance of a false positive disconnect.
· Frequency Detection
Used for Frequency Detection (Enable detecting the busy signal frequency or
not).
· Busy Frequency
If the Frequency Detection is enabled, you must specify the local frequency.
· Polarity Detection
Configure if the call needs to be hung up when a polarity signal arrived
3
）
Advanced Options
· Caller ID Start
This option allows you to define the start of a Caller ID signal:
Ring: Start when a ring is received (Caller ID Signaling: Bell_USA, DTMF).
Polarity: Start when a polarity reversal is started (Caller ID Signaling:
V23_UK,V23_JP,DTMF).
Before Ring: Start before a ring is received (Caller ID Signaling: DTMF).
· Caller ID Signaling
This option defines the type of Caller ID signaling to use. It can be set to one of
the following:
Bell: bell202 as used in the United States
v23_UK:
suitable in the UK
v23_Japan: s uitable in Japan
v23-Japan pure: suitable in Japan
DTMF: suitable in Denmark, Sweden, and Holland