MyPBX U300 Administrator Guide
115
Figure 20-13 Hot Standby Settings
Table 20-2 Description of Hot Standby Settings
Basic
Mode
Primary: set he device as the primary device.
Secondary: set the device as the standby device.
Secondary/Primary
Hostname
The hostname of the other MyPBX in the failover pair, which
must be different from that of the currently configured one.
Secondary/Primary
IP
The hostname of the other MyPBX in the failover pair, which
must be different from that of the currently configured one.
Access Code
The two MyPBX must have the same access code to
authenticate the connection.
Virtual IP Address
The users would communicate with the server with the virtual IP
address which is activated only on the current active MyPBX.
Generally, the two MyPBX in the failover pair should configure
the same
“Virtual IP Address”.The format should be “IP
address/Subnet mask
”.
E.g.
“192.168.6.20/255.255.255.255”.
Network Connection
Detection
Recommend to fill in the gateway IP address. If all the nodes
failed to be detected, it means that the network connection is
abnormal.
Note:
MyPBX would run as Standby server after the network
recovery.
Notification
Notification Methods
Set the notification method to inform users that the system is
down.
Email List
Enter the email addresses to send the notification when the unit
is down. Max: 8 email addresses.
Heartbeat Options
Keep Time
It sets the interval at which Heartbeat keep-alive packets are
sent. The default is 2.
