- 13 -
4.2 Installation Instructions
When using the rack to mount the device, the device must be hung on a wall that can
withstand a weight of 8 kg. If necessary, reinforce the wall.
Do not install the device on a wall that is damp, mildew, or cracked.
4.2.1 Install the wall bearing
4.2.1.1 The wall bearing is installed on the load-bearing wall
The wall is a solid bearing wall.
Using an electric drill to drill 4 suitable mounting holes on the wall perpendicular to the wall. The
hole diameter is 8mm and the depth is 40mm. The relative positions of the mounting holes are
consistent with the 4 small holes with a diameter of 6mm on the wall mount.
Put 4 M8×38 plastic expansion pipes into the mounting holes respectively, so that the plastic
expansion pipes enter the wall completely, and use a manual screwdriver to put the 4 cross recessed
pan-head tapping screws ST4.8×40 through the wall support. Screw the mounting hole of the seat
into the plastic expansion tube to fasten the wall-mounted bearing seat on the wall.
Load-bearing wall
Wall bearing
Plastic expansion tube
M8×38
Cross recessed pan head
tapping screws ST4.8×40
