INSTALLING YOUR
YEALINK W60B/W56H IP DECT PHONE
YEALINK W60 BASE
BASE POWER ADAPTER
ETHERNET CABLE
CONNECTING THE BASE STATION
You have two options to power the base station. Your System Administrator will advise you which one to use.
+
AC power (Optional)
+
Power over Ethernet (PoE)
NOTE:
Pay attention to the radio coverage of the base station. It is up to approximately 1000 feet in unobstructed
outdoor areas an up to approximately 165 feet inside buildings.
Do not set up the base station in a damp room, and keep it away from water.
AC Power (Optional)
+
Connect the DC plug on the power adapter to the DC5V port on the base station and connect the other end of the
power adapter into an electrical outlet.
+
Connect the included or any standard Ethernet cable between the Internet port on the base station and the Internet port in
your network or the switch/hub device port.
NOTE:
The base station should be used with the original power adapter (5V/600mA) only. The use of a third-party
power adapter may cause damage to the base station.
Need support? Connect with us at
or
Dial
4357 (HELP)
or
315-671-6262
to speak to a Northland Training Representative
