YATO YT-8245, Manual

Page: 9 / 40

9
GB
O P E R A T I N G M A N U A L
Before you turn an electric tool on remove all the spanners and other tools, which have been used for adjustments. A
spanner left on rotating elements of the tool may lead to serious injuries.
Keep your balance. Maintain an appropriate position. It will permit to control the electric tool in case of unpredicted situations
during its operation. Use protective clothes. Do not wear loose clothes or jewellery. Keep your hair, clothes and gloves
away from moving elements of the electric tool. Loose clothes, jewellery or long hair may get caught on moving elements of
the tool.
Use dust extractors or dust containers, if the tool is equipped with any. Make sure they are properly connected. Using of
dust extractors permits to reduce the risk of serious injuries.
Operation of the electric tool
Do not overload the electric tool. Use a proper tool for the given purpose. A correct selection of the tool for the given work
will result in a more efficient and safer work.
Do not use the electric tool if the switch is not functioning properly. A tool which may not be controlled by means of a switch
is dangerous and must be repaired.
Disconnect the plug from the mains socket before any adjustment, replacement of accessories or storage of the tool. It
will permit to avoid accidental activation of the electric tool.
Store the tool away from children. Do not allow untrained persons to operate the tool. An electric tool may be dangerous
in hands of an untrained person.
Make sure the tool is properly maintained. Check the tool in order to detects any unfitting or loose moving elements.
Check whether the elements of the tool are not damaged. In case any damaged elements of the tool are detected, they
must be repaired before the electric tool is operated. Many accidents are caused by improper maintenance of tools.
Cutting tools must be sharp and clean. Properly maintained cutting tools are easier to control during work.
Use electric tools and accessories in accordance with the aforementioned instructions. Use the tool in accordance with
its purpose, taking into account the kind and conditions of work. Should the tool be used for other applications than the ones
it has been designed for, the risk of a dangerous situation increases.
Repairs
The tool may be repaired only by authorised service centres, which must use solely original spare parts. It will guarantee
a proper level of safety of operation of the electric tool.
FITTING ACCESORIES
NOTE! Fitting of accessories must be executed exclusively with the power supply off (Remove the plug of the cord of the tool
from the socket!)
The soldering tool is supplied complete and does not require assembly.
OPERATING SAFETY INSTRUCTIONS
It is prohibited to use the soldering tool with a tapered soldering tip.
It is prohibited to touch the insulation of electrical cables with a hot soldering tip.
It is prohibited to use the soldering tool in high humidity conditions and in an atmosphere of explosive and caustic gases and dust.
Do not repair damaged electrical conductors of the tool.
In case the electrical cord of the tool is damaged, it must be replaced with a new one.
Replacement of a damaged electrical cord of the tool must be performed by a qualified electrician.
Do not solder live elements!
After work place the tool on its stand and wait until the soldering tool has cooled down. This is the only acceptable manner of
cooling the tool. Do not cool the soldering tool submerging it in water, since it may lead to an electric shock.
PREPARATION FOR WORK
Before work check whether the body and the cord with a plug and the external extension cords are not damaged. If necessary clan
the tool and the ventilating holes. If any damage is detected, it is prohibited to continue working!
Note! All activities related to replacement of the soldering tip, light bulb, etc. must be performed with the power supply of the tool
off, so before you proceed to execute them: Remove the plug of the cord of the tool from the socket!
Before using the tool, make sure the parameters of the mains comply with those indicated in the rating plate.
Before soldering clean thoroughly the metal elements to be soldered, as well as the soldering tip of the tool. In case the soldering
tip is burned, it must be replaced with a new one.