YATO YT-8245, Manual

Page: 10 / 40

10
GB
O P E R A T I N G M A N U A L
USING THE TOOL
Soldering should be performed by an adult who is acquainted with the safety regulations for soldering.
Note! The tool has not been designed for continuous operation! The maximum time of operation is 12 seconds, after which work
must be interrupted for at least 48 seconds.
MAINTENANCE AND INSPECTIONS
NOTE! Before any adjustment, technical service or maintenance, the plug of the tool must be removed from the mains socket.
Once work has been concluded check the technical conditions of the electric tool by means of visual inspection and evaluation
of the body and handle, the electric cord with the plug, operation of the switch, clearance of the ventilating holes, sparking of the
brushes, the level of noise emitted by the bearings and gears, start and smoothness of operation. Within the guarantee period,
the user must not dismantle the electric tool or replace any subassemblies or components, since it will make the guarantee void.
Any irregularities observed during inspection or operation of the tool indicate it must be repaired by a service centre. Once work
has concluded, the body, ventilating holes, switches, additional handle and protections must be cleaned, for example with an air
jet (whose pressure must not exceed 0.3 MPa), brush or a dry cloth, without any chemicals or cleaning liquids. The tool and the
handles must be cleaned with a dry, clean cloth.