YASKAWA TOEPYAIUPW02A U1000 iQpump Drive Quick Start Procedure
U1000 iQpump Drive
Quick Start Procedure
Page 10
of 25
Application Setup
6
STEP
6.1
Configure the drive for a dedicated pump application.
DO NOT RUN THE MOTOR. Ensure all protective covers are installed and power is turned
on.
Select one of the Application Macro settings shown below from Initialization parameter A1-03. Refer to Step 6.2 for an example of
setting a parameter using the keypad.
•
0: No Initialization
(Factory Default)
•
1110: User Initialize (parameter values will be stored using parameter o2-03)
•
2220: 2-Wire Initialize
•
3330: 3-Wire Initialize
•
5550: Terminal->Control Initialize
•
6008 Pressure Control (PSI)
•
6009 Pump Down Level Mode (Ft)
•
6011 VTC Pressure Control Mode
•
6012 VTC Pivot Panel Mode
•
6013 Advanced Pressure Control Mode
•
6014 Pivot Panel Submersible Mode
•
7770 General Purpose
•
7771 General Purpose Submersible Motor Mode
6.2 Application Macro setting example using parameter A1-03.
Keypad Example: Setting Parameter A1-03
Press key to display the main menu, then press .
Select Digit
2X
Increase/Decrease
Selection
Select Application
Switch to Edit Mode
Press to select
.
2X
ENTER
ENTER
ENTER
U1-02= 0.00Hz
U5-99= 0.0
PSI
Auto Setpoint
- MODE - DRV Rdy
U1-91= 0.0PSI
MONITOR
LSEQ
LREF
Programming
- MODE - PRG
FWD
HOME
Select language
- PRMSET- PRG
Select Language
A1-
00
= 0
FWD
HOME
Init parameters
- PRMSET- PRG
No Initialize
A1-
03
= 0
FWD
HOME
Init parameters
- PRMSET- PRG
No Initialize
"0"
FWD
HOME
A1-
03
=
0
*0*
Init parameters
- PRMSET- PRG
Pressure Control
"0"
FWD
HOME
A1-
03
=
6008
*0*
ENTER
F1
