Click "Search" It should find the drive. Then select and click "connect".
Choose Parameters -> Edit Parameters from the top menu.
Select "Import" from the top right. Navigate and select the needed parameter file. It may give you a warning,
just select "yes".
Check the "Select all" box in the lower left, then click "Write" in the lower right.
The drive should now have the correct parameters. Turn the power off to the drives and back on to enact the
changes. You can use the soft reset as well from the menu icon in the main software screen.
9817
Summary of Contents for SGDV-R70F
Page 25: ...Factor and Offset Analog Monitor 1 Pn006 XX02 Load Meter...
Page 31: ...Install Standoff Install Buffer Board...
Page 32: ...Reinstall mounting screw Install jumper on servo adaptor J5 pin 2 3 next to the labeled SEN...
Page 33: ...Install wire from Buffer Board to all Yaskawa servo adaptors for SEN signal...
