INSTALLATION
MOTO
MAN
4-9
MH–Series Positioner Manual with MotoMount
4. Remove top cover and attach eye bolts to top of the housing and lift.
5. Place headstock in position.
NOTE:
Make sure there is adequate room on all sides of the positioner for parts fixturing.
4.3.3
Floor Mounting – Type II
Figure 4-9 provides dimensions for accurately floor mounting the MH1000/3000
headstocks.
Figure 4-9 MH1000/3000 Mounting Hole Pattern
Installing the Type II Headstock
Before proceeding, refer the system layout drawings to ensure precise set up
location. Refer to Figure 4-10 to install the headstock, and proceed as follows:
1. Set headstock assembly in desired position.
2. Use leveling bolt holes as a guide and transfer the hole locations to the
concrete.
3. Remove headstock assembly.
4. Install the anchors per the manufacture’s instructions.
5. Install a leveling shim at each anchor location and reset the column assembly.
6. Screw each leveling bolt down until it just contacts the leveling shim and
hand tighten the anchor bolts or nuts.
1110.0 MM
(43.7 IN)
45 MM
(1.77 IN)
415.0 MM
(16.3 IN)
695.0 MM
(27.3 IN)
45 MM
(1.77 IN)
710.0 MM
( 27.9 IN)
6 X CLEARANCE FOR
M12 (1/2 IN.) ANCHOR
