
4 Electrical Installation
12
YASKAWA ELECTRIC
TOBP C730600 39A YASKAWA AC Drive-Option Card DI-A3 Installation Manual
3.
Wire the option card to the terminal block on the option card.
For wiring instructions, see
Connection Diagram on page 13
.
In the drives CIMR-A
2A0004 to 0040, 4A0002 to 0023 the cable might need to be
routed through the top cover to the outside. In this case cut out the perforated
openings at the left side of the drive top cover. Make sure no sharp edges that can
damage the cable remain.
In the drives CIMR-A
2A0056 to 0211, 4A0031 to 0165 the cable can be routed
inside the drive.
Figure 4
Figure 4 Wiring space
4.
Place the front cover back onto the drive.
Note: 1.
Take care when wiring the option card so that the front cover easily fits back onto the drive. Make sure
a cable is not caught between the front cover and the drive when putting the cover back on.
2.
The drive will not be used as NEMA Type1 if there is any exposed wiring outside the enclosure.
A – Wires should pass through the
access hold provided on the left
side of the front cover.
(CIMR-A
2A0004 to 0040, 4A0002
to 0023)
B – Use the open space provided
inside the drive to route option
card wiring.
(CIMR-A
2A0056 to 0211, 4A0031
to 0165)
A
B