YASKAWA CC-Link SI-C3, Technical Manual

Page: 50 / 62

10 CC-Link Code Numbers List
50 YASKAWA SIEP C730600 83E CC-Link Technical Manual
Command Code (Hex.) Name Description
007A Fault History 7 Reads the contents from U3-07 [7th MostRecent Fault] .
0080 Fault History 8 Reads the contents from U3-08 [8th MostRecent Fault] .
0081 Fault History 9 Reads the contents from U3-09 [9th MostRecent Fault] .
0082 Fault History 10 Reads the contents from U3-10 [10th MostRecentFault] .
007B Read LOCAL/REMOTE status
Bit 0: 0 = Frequency reference from CC-Link is enabled.
Bit 1: 0 = FWD/REV Run command from CC-Link is enabled.
00FB Write LOCAL/REMOTE status
Bit 0: 0 = Frequency reference from CC-Link is enabled.
Bit 1: 0 = FWD/REV Run command from CC-Link is enabled.
When power is cycled, however, the source is determined by b1-02 [Run Command
Selection 1] .
- Read Parameters Adds 1000 (Hex.) to the MEMOBUS/Modbus register number.
- Parameter Settings
Master executes commands by adding 2000 (Hex.) to the MEMOBUS/Modbus register
number. Conversion takes place on the option side.
00F4 Clear All Fault Contents 9696 (Hex.): Clear fault history
00FD Reset Converter 9696 (Hex.): Fault reset
■
D1000 Extended Command Codes
Table 10.7 D1000 Extended Command Codes
Command Code Name
Read (Hex.) Write (Hex.) BIT
100 -
Operation Signals
0
Run Command
*1
Automatic Run Command/Stop Command
*1
1
Forced Run command/Stop Command
2
External Fault
1: EF0 [Option Card External Fault]
3
Fault Reset
1: Reset Command
4
Multi-Function Input 1
5
Multi-Function Input 2
6 Multi-Function Input 3
7
Multi-Function Input 4
8
Multi-Function Input 5
9
Multi-Function Input 6
A Multi-Function Input 7
B
Multi-Function Input 8
C - F
Reserved
105 205 Multi-Function Analog Monitor Output Terminal 1
106 206 Multi-Function Analog Monitor Output Terminal 2
107 -
Multi-Function Relay Output
0
Multi-Function Contact Outputs (Terminal M1-M2)
1: ON
0: OFF
1
Multi-Function Photocoupler Output 1 (Terminal P1-PC)
*2
1: ON
0: OFF
2
Multi-Function Photocoupler Output 2 (Terminal P2-PC)
*2
1: ON
0: OFF
3 - 5
Reserved
6 1: Bit 7 Function Enabled
7
1: Fault Contact Output (Terminal MA/MB-MC)
1: ON
0: OFF