model no. 060-3714-0 | contact us: 1.866.523.5218
PROBLEM
POSSIBLE CAUSE
SOLUTION
The handle
is not in
position.
The bolts are not properly
seated.
Make sure the bolts are
correctly installed through the
handle bars. Check to see if the
hand knobs are tight. Refer to
Assembling the Handle section
in this manual.
The
snowthrower
does not start.
The switch is defective.
Have the switch replaced by an
authorized service centre.
The extension cord is not
connected to the plug.
Connect the plug on the
snowthrower to the extension
cord.
The extension cord is not
connected to the power
source.
Plug the extension cord into a
live 120 V AC, 60 Hz outlet.
The motor is
on, but the
impeller does
not turn.
The belt is damaged.
Replace the belt (see the section
entitled Replacing the Drive
Belt).
The
snowthrower
leaves a thin
layer of snow
behind.
The scraper is worn.
Inspect the scraper for wear or
damage. Replace the scraper
(see the section Replacing the
Scraper).
24
Tr
oubleshooting
