model number 054-5764-4 | contact us: 1.866.523.5218
21
4. CUTTING
$IFDLPJMMFWFMHBVHFQSJPSUPTUBSUJOHBOESFHVMBSMZEVSJOHPQFSBUJPO3FªMMPJMXIFOPJMMFWFMJT
MPX5IFPJMUBOLªMMJOHXJMMMBTUBQQSPYJNBUFMZNJOVUFTEFQFOEJOHPOTBXJOHJOUFOTJUZBOE
stops.
$POªSNUIFDIBJOUFOTJPOJTJOXPSLJOHPSEFSBOEUIFDIBJOTIBSQ
Check newly replaced chain tension during operation.
Upon initial operation, new chains can lengthen considerably. The condition of the chain
JO«VFODFTUIFDVUUJOHQFSGPSNBODF0OMZBTIBSQDIBJOQSPUFDUTGSPNPWFSMPBE
Make sure you are wearing the necessary protective equipment.
Wear safety glasses/goggles/visor, safety helmet and hearing protection.
Further protective equipment for head, hands, legs and feet is highly recommended.
"EFRVBUFQSPUFDUJWFDMPUIJOHXJMMSFEVDFQFSTPOBMJOKVSZCZ«ZJOHEFCSJTPSBDDJEFOUBMDPOUBDU
with saw chain.
Proper functioning of the automatic oiler can be checked by running the chainsaw and pointing
the tip of the chain bar towards a piece of cardboard or paper on the ground.
!
Caution: Do not touch the ground with the chain. Ensure safety clearance of 8” (20
DN*GBOJODSFBTJOHPJMQBUUFSOEFWFMPQTUIFBVUPNBUJDPJMFSJTPQFSBUJOHªOF*GUIFSFJT
no oil pattern, despite a full oil reservoir, see “Troubleshooting”.
5. KICKBACK (See Fig. I1, I2)
KICKBACK is the backward, upward or sudden forward motion of the guide bar occurring when
UIFTBXDIBJOOFBSUIFVQQFSUJQPGUIFHVJEFCBSDPOUBDUTBOZPCKFDUTVDIBTBMPHPSCSBODIPS
XIFOUIFXPPEDMPTFTJOBOEQJODIFTDIBJOJOUIFDVU$POUBDUJOHBGPSFJHOPCKFDUJOUIFXPPE
can also result in loss of chainsaw control.
8IFOLJDLCBDLPDDVSTUIFDIBJOTBXSFBDUTVOQSFEJDUBCMZBOEDBODBVTFTFWFSFJOKVSJFTUPUIF
operator or bystanders. Particular attention must be given when sawing sideward, slanted or
during length cuts, as the spiked bumper usually cannot be applied.
To avoid kickback:
4BXXJUIHVJEFCBSBUB«BUBOHMF
•
Never work with a loose, widely stretched or heavily worn-out chain.
•
Ensure chain is sharpened correctly.
•
Never saw above shoulder height.
•
Never work with the tip of the guide bar.
"MXBZTIPMEUIFDIBJOTBXªSNMZXJUICPUIIBOET
•
Always use a low kickback chain.
•
Apply the metal gripping teeth for leverage.
•
Ensure correct chain tension.
Assembly
