13
Avery Inst 1 - Post Assembly
Avery Inst 1 - Post Assembly
Avery Inst 1 - Post Assembly
A:
At the bottom of one (696) 6 x 6 Post insert two 5/16” T-Nuts as shown in fig. 2.1.
B:
At the bottom of the same (696) 6 x 6 Post place two Post Mounts tight to the bottom and inside faces as
shown in fig. 2.1 and 2.2. Loosely attach with one 5/16 x 1-1/4”
Hex Bolt (with 5/16” lock washer and 1/4-5/16”
large washer) per mount so they connect to the T-Nuts. From the bottom attach with two #8 x 1-3/4” Wood
Screws per mount and then from the inside with two #10 x 1-1/4” Pan Screws per mount These screws are
installed at a slight angle. Tighten bolts.
C:
Place one (422) Plinth flush to the bottom and tight to the Post Mounts on each side of the (696) 6 x 6 Post
and attach with four #8 x 1-3/4” Wood Screws per plinth. Rounded edges on top. (fig. 2.3 and 2.4)
D:
Repeat Steps A - C three more times to make four Post Assemblies.
Step 2: Post Assemblies
Hardware
Wood Parts
Fig. 2.1
(422) Plinth
4 x (696) 6 x 6 Post
16 x (422) Plinth
Top
Bottom
#8 x 1-3/4” Wood Screws
(x 2 per Post Mount, from
bottom)
#8 x 1-3/4”
Wood Screws
(x 4 per Plinth)
(696) 6 x 6 Post
Post
Mount
Fig. 2.2
16 x #10 x 1-1/4” Pan Screw
80 x #8 x 1-3/4” Wood Screw
8 x Post Mount
8 x 5/16” T-Nut
8 x 5/16 x 1-1/4” Hex Bolt
(with 5/16” lock washer, 1/4-5/16” large washer)
Avery Inst 1 - Post Assembly
Fig. 2.4
Post
Mount
(696) 6 x 6 Post
5/16” T-Nut
(x 2 per
Post)
(696) 6 x 6
Post
Rounded
Edge on Top
Fig. 2.3
Post
Mount
#10 x 1-1/4” Pan Screws
(x 2 per Post Mount, from
inside)
1/4 - 5/16”
Large Washer
5/16” Lock
Washer
5/16 x 1-1/4”
Hex Bolt
5/16” T-Nut
(x 2 per
Post)
(696) 6 x 6
Post
