21
Hardware
Wood Parts
Fig. 7.5
Side View
D:
Tight to each (465) Long Strap place one (466) Short Strap and tight to the first (466) Short Strap place one
(465) Long Strap. Make sure the wider gap on each strap is on the outside. Make sure the assembly is square,
pre-drill the first (466) Short Strap with a 1/8” drill bit, as shown below, then attach both (466) Short Straps with
six #8 x 1-3/4” Wood Screws per board and (465) Long Strap with ten #8 x 1-3/4” Wood Screws. The screws
where the straps meet are inserted at an angle. (fig. 7.3 and 7.5)
E:
Tight to (469) Rafter Top Short attach one (467) Rafter Top with eight #8 x 2-1/4” Wood Screws. (fig. 7.4 and
7.5)
Step 7: Frame Roof Panel
Part 2
Notice
screws at
an angle
Fig. 7.3
Notice large
notch gap on
outside ends
Notice small notch
gap on inside ends
where straps meet
Notice large
notch gap on
outside ends
Avery Inst 6A - Frame Roof Panel
(467)
Rafter Top
Flush
(468)
Rafter
Fig. 7.4
#8 x 2-1/4”
Wood Screws
(x 8)
(466) Short Strap
(pre-drill pilot holes
for this board only)
(468) Rafter
#8 x 1-3/4”
Wood Screws
(x 22)
4 x (466) Short Strap
2 x (465) Long Strap
2 x (467) Rafter Top
44 x #8 x 1-3/4” Wood Screw
16 x #8 x 2-1/4” Wood Screw
Bottom
(466) Short
Strap
(465) Long
Strap
(466) Short
Strap
(465) Long
Strap