Step 5.
Fasten the side tabs of the bracket using 1 3/4” washer head
screws.
Step 7.
Install the beam strap (3E) on the other end of the beam using the
same 4 7/8” threaded rods.
Only finger tighten the nuts at this point.
Step 6.
Attach the swing beam bracket (3G) to the end of the beam
without the end caps.
Use two 4 7/8” threaded rods with washers and acorn nuts to
fasten the bracket.
Step 8.
Find the 4x4 end post (3B) and place it in the beam strap.
Make sure the post is square with the swing beam then tighten all
the nuts.
