19
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
The handle is not in
position.
The bolts are not properly seated.
Make sure the bolts are correctly
installed through the handle bars.
Check to see if the hand knobs
are tight. Refer to Assembling the
Handle, page 12.
The snowblower does not
start.
The switch is defective.
Battery is out of power.
Have the switch replaced by an
authorized service centre. Charge
the battery.
The motor is on, but the
impeller does not turn.
The belt is damaged.
Replace the belt. Refer to
Replacing the Belt and Pulley,
page 18.
The snowblower leaves a
thin layer of snow behind.
The scraper is worn.
Inspect the scraper for wear or
damage. Replace the scraper.
Refer to Replacing the Scraper
Bar, page 17.
