![background image](http://html1.mh-extra.com/html/yard-force/yf60vrx22-st/yf60vrx22-st_operators-manual_3173591018.webp)
18
3. Install the new scraper bar and fasten it
securely to the snowblower with the two
screws (Fig. 30).
Fig. 30
REPLACING THE BELT AND PULLEY
NOTE:
Determine the left and right hand side of
the snowblower by standing behind the unit in
the normal operating position.
1. Remove the screws from the left panel of
the snowblower and remove the left panel
(Fig.31).
2. Lift the belt tension pulley and roll the worn
belt up and off the big pulley from the top of
the big pulley (Fig. 32).
Belt Tension
Loosen
Tighten
Big Pulley
Belt
Fig. 32
Fig. 31
3. To replace the big pulley, remove the screw
and washer from the middle of the pulley.
While securing the paddle, so it does not
spin, use a 7/8-inch socket to turn the outer
nut of the pulley clockwise (the pulley is left-
handed, so loosening and tightening occur in
reverse orientation; clockwise to loosen and
counter-clockwise to tighten). Once the old
pulley is removed, replace the big pulley and
tighten the outer nut counter clockwise with
the 7/8-inch socket. Replace and tighten the
screw and washer (Fig. 32).
NOTE:
Heavy wet snow puts a load on belts,
thus requiring more frequent belt replacement.
4. To ins tall the new belt, lift the belt tension
and roll the new belt onto the little pulley
at an angle. Then roll the belt onto the
top of big pulley by rotating the big pulley
counterclockwise as the belt grips the top of
the big pulley (Fig. 32).
5. Replace the left panel of the snow blower
with all screws (Fig. 31).
AUTOMATIC RESET
This snowblower has built - in automatic reset
functions. In the event of a major obstruction that
halts paddle movement, simply remove the batterey,
clear the paddle obstruction, wait 60 seconds,
and then resume use of your machine.