13
Fig. 9
CHUTE CRANK ASSEMBLY
1. Remove the cotter pin from the lower chute
crank (Fig.10).
2. Install the lower crank rod by inserting it into
the opening at the back of the housing with
holes aligned (Fig.11).
3. Secure the lower chute crank in place with
the cotter pin (Fig.12).
Cotter Pin
Cotter Pin
Align the
holes
Lower Chute
Crank
Lower Chute
Crank
Fig. 10
Fig. 11
Fig. 12
4. Remove the cotter pin on the crank rod
connector by hand (Fig.13).
5. Slide the upper chute crank through the
rubber ring located on the middle frame
(Fig.14).
6. Slide the upper chute crank into the crank
rod connector (Fig.15).
7. Align the holes and insert the cotter pin by
hand (Fig.16).
Cotter Pin
Fig. 16
Upper Chute
Crank
Upper Chute
Crank
Crank Rod
Connector
Rubber Ring
Cotter Pin
Crank Rod
Lower Chute
Crank
Fig. 14
Fig. 15
Fig. 13
NOTE:
Before using this machine, make sure
that the power source you will use complies
Before inserting the battery to start, verify that
the snowblower’s roll shaft and rubber plates are
plates are facing the correct direction. Perform a
test run to ensure that the motor turns freely.
