120v
LITHIUM-ION
TM
14
To insert the battery pack
1. Align the groove on the battery pack with the
corresponding ribs in the receptacle of the
device. (See Fig. 7)
2. Depress the battery pack with moderate force
until it is locked in place. Make sure that the
battery handle is folded down. (See Fig. 7)
Battery Pack Y0L120BAT2.5 (See Fig. 14)
1. Lift handle
2. Main housing
3. Indicator button
4. Green LED lamps
5. Red LED lamp
Battery Pack Operation (See Fig. 15)
1. When you push the power indicator button, the
green LED lights will show the power remaining.
(See Fig. 15
①
)
2. When the battery pack over discharges or
remains very low power, the red LED light will
flash. (See Fig. 15
②
)
3. When the battery pack temperature is exceeded,
the red LED light will flash. Cool it down for
10~20 minutes. (See Fig. 15
②
)
4. When there is fault with the battery pack, the red
LED light will flash. (See Fig. 15
②
)
5. Once the battery pack is correctly located in the
charger, the 4 green LED lights of the battery
pack will flash LED lights to indicate the charging
process. At the same time the green LED light of
the charger will flash continuously during normal
charging, while the red LED light is still on. (See
Fig. 15
③
)
To remove the battery pack from the tool
1. Press the battery pack release button, the
battery pack will spring out automatically. (See
Fig. 8)
2. Lift up the carrying handle and remove the
battery pack. (See Fig. 8)
Switch ON the chain saw
1. Depress the power button and hold down for
2 seconds- The green LED light will be ON.
This means the tool is power on normally. (See
Fig. 9)
2. Make sure the Chain Brake lever is in the
OFF position – (pulled backwards towards the
rear). (See Fig. 10)
3. Grip the main handle with your right hand and
auxiliary handle with left hand.
4. Press the safety lock off button with your
thumb and then grip the switch trigger. (See
Fig. 11)
Switch OFF the chain saw
Depress the power button and hold down for 2
seconds- All LED lights will be OFF. (See Fig. 12)
Make sure the Chain Brake lever is in the ON
position. (See Fig. 13)
Caution:
Always switch off the chain saw when work break
or long time storage, ensure the Chain break
lever is in the ON (lock) position.
Before use
1. Check that the chain brake works correctly
and is not damaged.
Check the operation of the chain brake prior to
each use.
Engage the chain brake by rotating your
left hand around the front handle and then
allowing your hand to push forward the chain
brake lever guard while the chain is rotating
at normal speed. Make sure you have both
hands on the chainsaw at all times. The chain
should stop immediately.
Reset the Chain brake lever by pulling the
brake lever back toward the handle.
2. Check that the rear right hand guard is not
damaged.
3. Check that the lock-off button and on/off trigger
switch works correctly and is not damaged.
4. Check that all handles are free from oil.
5. Check that all parts of the chain saw are
tightened correctly and that they are not
damaged or missing.
6. Check the chain tension.
Correct posture
1. Never work on unstable surfaces!
2. Never work while standing on a ladder!
3. Do not lean too far forward or too far back!
4. Use the product only under favorable weather
and site conditions!
5. Stand with both legs securely on the ground.
Watch out for obstacles in the work area.
