120v
LITHIUM-ION
TM
13
Operation
Charging the battery pack
NOTE:
- The battery pack is supplied partially charged.
To ensure the best performance, charge the
battery completely before first use.
- Make sure the main voltage is the same as
rating label which is located on the charger.
- Remove the battery pack from the charger
after it has been fully charged.
1. Connect the charger to a power supply. The
red LED light on the charger will be on.
2. To insert the battery pack into the charger, align
the grooves on the battery pack with the raised
ribs in the opening of the charger. Then press
the battery pack downward with a moderate
force. (There is a carrying handle at the top of
the battery pack. Lift the handle up for easy-
transporting.)
3. Once the battery pack is correctly located in
the charger, the green LED light of the charger
will flash continuously during normal charging,
while the red LED light is still on.
4. When charging is complete, both green and
red LED light of the charger will be on.
5. If you encounter one of following kind of
situations, the red LED light of charger will
flash.
- Wrong communication. It refers to poor
connection between charger and battery pack.
- Fault with battery pack. It need be repaired by
the customer service center.
Power indicator
This Li-Ion battery pack is equipped with a power
indicator which is used to show the battery pack’s
remaining charge. Press the power indicator
button to check battery charge as below. The
LEDs will stay lit for approximately 4 seconds.
Meaning of power indicator
1. When you push the power indicator button,
the green LED lights will show the power
remaining.
2. When the battery pack over discharges or
remains very low power, the red LED light will
flash.
3. When the battery pack temperature is
exceeded, the red LED light will flash. Cool it
down for 10~20 minutes.
4. When there is fault with the battery pack, the
red LED light will flash.
5. Once the battery pack is correctly located in
the charger, the 4 green LED lights of the
battery pack will flash LED lights to indicate the
charging process. At the same time the green
LED light of the charger will flash continuously
during normal charging, while the red LED light
is still on.
Low capacity warning
Unlike other battery pack types, lithium-ion
battery packs deliver fade-free power for their
entire run time. The tool will not experience a
slow, gradual loss of power as you work. If the
red LED on the battery pack begins to flash, the
battery pack’s charge is below 1% capacity and
should be recharged.
To obtain the best life from the battery
1. Never allow the battery to completely
discharge before recharging. The battery pack
should be placed on the charger whenever
the battery pack is noticeably running down or
the tool no longer performs a task it previously
performed.
2. Avoid conducting short charges. Make sure
that the battery is fully charged each time
by allowing the charger to complete its full
charging cycle.
3. Avoid allowing lose items like screws or nails
etc. to be stored with battery packs as these
or similar items can short battery packs and
cause a fire or explosion
4. Always unplug the charger when not in use
and store in a dry and secure place.
5. Avoid charging or storing your battery in
temperatures below 41˚F and above 113˚F.
6. After use, allow the battery to pack to cool
down for approximately 30 minutes before
attempting to recharge.
Filling the chain oil tank
1. Open the chain oil tank cap. (See Fig. 6)
2. Fill ONLY with Chain OIL - 406 Lubricating Oil
3. Reinstall oil tank cap. Tighten firmly.
4. Wipe off excess oil.
NOTE:
It is normal for oil to seep when saw is not
in use. Empty oil tank after each use in case of
seepage.
