![background image](http://html1.mh-extra.com/html/yard-force/sa600h/sa600h_original-instructions-manual_905801014.webp)
26
27
NOTE! When the working area is less than 100 m
2
or
total boundary wire less than 40 m, please integrate the
supplied 10 Ω / 20 W cement resistance to the boundary
wire.
<
100 m
2
Robomower cutting information
• The Robomower has a cutting height setting between
20 mm to 60 mm. If the grass height exceeds 60 mm,
cut it to 60 mm or below before using the Robomower.
Otherwise the load on the unit will be too large and the
cutting efficiency will suffer, we recommend using an
ordinary lawn mower or trimmer. Once the installation is
complete, adjust the cutting height to the desired setting.
Always start in a high cutting position and work your way
down to the cutting height you want. Before adjusting
the cutting height, always press the STOP button (2) to
interrupt the cutting. Then turn the large dial to adjust the
cutting height.
Note:
Only adjust the cutting height while the
Robomower is switched off.
• Do not use the Robomower during lightning or thunder
storms. In case of damage to the electronic circuitry,
unplug the charging station and - if possible - disconnect
the boundary wire.
The Robomower cutting efficiency relies on sharp
blades, so please keep them in good condition.
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS